|
libximc
2.9.12
|
Feedback settings. More...
Data Fields | |
| unsigned int | IPS |
| The number of encoder counts per shaft revolution. | |
| unsigned int | FeedbackType |
| Feedback type. | |
| unsigned int | FeedbackFlags |
| Describes feedback flags. | |
| unsigned int | HallSPR |
| The number of hall steps per revolution. | |
| int | HallShift |
| Phase shift between output signal on BLDC engine and hall sensor input(0 - when only active the Hall sensor, the output state is a positive voltage on the winding A and a negative voltage on the winding B). | |
Feedback settings.
This structure contains feedback settings.
| unsigned int FeedbackFlags |
| unsigned int FeedbackType |
| int HallShift |
Phase shift between output signal on BLDC engine and hall sensor input(0 - when only active the Hall sensor, the output state is a positive voltage on the winding A and a negative voltage on the winding B).
| unsigned int HallSPR |
The number of hall steps per revolution.
| unsigned int IPS |
The number of encoder counts per shaft revolution.
Range: 1..655535. The field is obsolete, it is recommended to write 0 to IPS and use the extended CountsPerTurn field. You may need to update the controller firmware to the latest version.
1.8.2